Technical Specifications:

The following are a few technical specifications that need to be noted when operating or taking apart the MSP-3 probe.

• The maximum current allowed to each current lead is 1000 amps.
• The time limit of current being applied is a pulse of 10 seconds.
• Pressure is released at the pressure relief valve when the pressure inside the probe exceeds 1 psi.
• A weight relief is not needed for this probe.
• The distance between the helium exhaust holes in the bottom spacer and the temp sensor is 2.5 inches..
• The gear ratio between the stepper motor and the sample selection mechanism is 4:1.
• The current contact IS silver coated to improve electrical conductivity.

• Eight samples are available to be tested during one run.
• Only one sample can be measured at a time.

• PRECAUTION: - DO NOT DROP PROBE.

- REST ON BOTTOM END (SUPPORT) OR ON DESIGNATED MSP-3 STORAGE

RACK WHEN STORING FOR EXTENDED TIME PERIODS.

- THIS PROBE IS DESIGNED TO BE USED ONLY BY TRAINED PERSONNEL

- THE PROBE USES AN EXTREMELY LARGE AMOUNT OF CURRENT, THUS MAY

CAUSE BODILY HARM IF USED IMPROPERLY